|
|
| *Home>>>Maintenance & Repairs |
How do you keep the end of a tube of glue from sealing up? |
It always seems that when you put the glue away and get it back out later, the little hole in the applicatior is seald shut. Mostly with Superglue and Gorilla Glue. Thumb tacks do wonders, especially those plactic handled ones. You can also use a tooth pick to clean out the hole before you put the glue away. Store in upright position, do not lay it on a side (a small jar will help do this). You are welcome. Report Abuse jus keep a pin in the hole when your not using it |
| Related information |
Try Dawn Dishwashing detergent and a soft sponge. If it works for getting oil slick oil off birds, it should work for you. My cat fell into a pan of old oil my husband had drained out of the c... Drain the pool some so you can work on the drain. Purchase a product called 'herculeese' epoxy putty from a plumbing supply store. Use it according to the directions and it will seal ar... I used to work in insurance, and the company I worked for generally replaced all furniture and carpets that were smoke damaged - they did say that the restoration co could get rid of most of the sm... Remove the outer cushion covers and run them through the wash. ...witch;s brew~ kidding~ on mine i first used cat litter as you know already.Then I poured a box of Baking Soda first then on top of this/Go-Jo Hand Cleaner,I let it stay on the stain over night.t... First of all, where is the source of the moisture? You need to stop the moisture at its source. Caulking between the floor and the drywall won't help, the moisture will penetrate the wall and ... The blue green color is from copper oxide. There must have been moisture and a small amount of oil on the contacts and it caused some oxidation. ...Mseal or any good "wall putty" ... |
Categories--Copyright/IP Policy--Contact Webmaster |