![]() |
|
| *Home>>>Maintenance & Repairs |
How do you get paint off a wood dresser? |
I was painting my bedroom and got a few drops of paint on my light oak dresser. How do I remove it without ruining the wood? I'm pretty sure you used latex paint. For just a few drops, scrape it off with your fingernail. That way you won't ruin the finish. After you have most of it off, use a damp cotton rag to wash it off. Then use some type of furniture oil like liquid gold, put it on a little heavy, wait a few minutes then wipe off. Should be good as new. If you try to wash it off with water, you might rub the color in more. If you use any type of nail polish remover, paint remover, etc, you'll eat the finish off before the paint is gone. A good paint remover should be used first. depending on the type and condishion of the paint you could just sand it off if the paint is in good order and you think it might be a oil base get a paint stripper and a wood brighter If it's latex paint just use a damp sponge with warm water. If oil based, you could use a dab of lacquer thinner. sand paper I was told once that nail polish remover would work. I would check on an inconspicuous spot first to make sure it doesn't take the original finish off of your dresser... nail polish remover try using some water and then waxing the wood...if it's oil based paint, try some furniture oil...pour some on and let it set, then try to rub it off with a paper towel... dab paint thinner on a washcloth and run quickly on area of paint. |
| Related information |
An air cushion can fill with water. To restore the air to all air chambers, turn off the main shutoff valve and completely drain the water -supply system. Open all faucets to let air in. Then close... The agitator should pull up out of the machine (not easily, but it shouldn't take a crowbar either). Clean everything below it. Unhook all the lines, and pull the machine away from the wall... Take out the baskets and everything else you can. You have already gotten it into the spray arms but it should have cleaned itself out by now. AT any rate, clean out the interior of the washer an... baseboard and quarter round moulding ...you have a 220 pigtail on your dryer,you need to make sure your outlet is 220,not 110,if it is, you can either change the outlet to the other 220 outlet or the pigtail to match your outlet, pigtail... The first two posts are correct: As much as I love old hardwood surfaces, if the floors are that old, you may want to consider just replacing them with a newer quality hardwood surface...if you ... i think you have already got the right idea the biggest challenge is will it go moldy ? you deffinatly want something under it and then i would space out boxes againt it as you said so the matteras... Anything that would dissolve polyurethane glue (such as Gorilla Glue) will take your carpet right along with it. The best you can hope for is to scrape, pick, or maybe comb out most of it. ... |
Categories--Copyright/IP Policy--Contact Webmaster |