www.todaysmodernwoman.com
*Home>>>Maintenance & Repairs

Is there any hope for a dishwasher, where my daughter poured comet with bleach in there, and after 10 times?


running it empty, there are plenty of "soap" bubbles there? What would need to be done to get it rid of the comet?

Take out the baskets and everything else you can. You have already gotten it into the spray arms but it should have cleaned itself out by now. AT any rate, clean out the interior of the washer and pour water into it. Then you can close the door and start the cycle. the first thing it will do is activate the drain cycle. When the water has drained out, open the door and fill it back up with water and close the door and let that drain out. Sooner or later, the comet has to flush out. Good luck.

try vinegar it will neutralize almost anything.

sure just clean it out and keep using the rinse cycle neither of those should cause any permanent damage

.
Even if there are soap bubbles coming out it should not hurt to wash dishes in it since all dish detergents have bleach in them. Just don*t add any detergent to the load when you do dishes. Eventually it will clean itself . You are just wasting water running it on empty.
Add some vinegar to the last rinse to do away with water spots.

Get in there and clean out as much as possible, then run some empty batches through it, it may take several but, it's a heck of a lot cheaper then getting a new one, there one thing in your favor, it'll be clean.

Try vinegar.......somehow.

Use vinegar or 2 Alka-Seltzer tablets

I would open the dishwasher , remove the baskets and wash out by hand with a wet cloth. remove the filter and wash it out then pour some water into the washer and if you can set it to drain , pour more water through it .

You might be able to wash out the detergent dispenser if thats where she poured the comet.

Buy a new machine and have yoru daughter pay for it.

Capful of fabric softener. It'll cut the suds.

Tags
  Ethnic Cuisine   Entertaining   Cooking & Recipes   Beer, Wine & Spirits   Other - Home & Garden   Maintenance & Repairs   Garden & Landscape   Do It Yourself (DIY)   Decorating & Remodeling   Cleaning & Laundry   Other - Family & Relationships
Related information
  • What should I use to cover a gap between my floor and wall?

    baseboard and quarter round moulding

    ...
  • Where can I find an electrical plug adaptor for my clothes dryer?

    you have a 220 pigtail on your dryer,you need to make sure your outlet is 220,not 110,if it is, you can either change the outlet to the other 220 outlet or the pigtail to match your outlet, pigtail...

  • What is the best way to remove minor scratches from a hardwood floor?

    The first two posts are correct: As much as I love old hardwood surfaces, if the floors are that old, you may want to consider just replacing them with a newer quality hardwood surface...if you ...

  • How to position mattress in storage room?

    i think you have already got the right idea the biggest challenge is will it go moldy ? you deffinatly want something under it and then i would space out boxes againt it as you said so the matteras...

  • How can I remove Gorilla Glue from my carpet?

    Anything that would dissolve polyurethane glue (such as Gorilla Glue) will take your carpet right along with it. The best you can hope for is to scrape, pick, or maybe comb out most of it.

    ...
  • How far away can an indirect water cylinder be from the heat source using a gravity circuit?

    These things are usually expressed as a ratio of rise over run, the distances can be manipulated with varying pipe diameters and insulation factors. With a little more info, I might be able to help...

  • How do I stop water from seeping through my poured concrete foundation?

    See if you can lead the water that comes down the gutters and downspouts away from the foundation. You can get 4 or 6 inch pipe that receives this water, and sends it downhill away from the house...

  • How much does it cost to repair a leaky skylight and the damage the leak has caused?

    call a roofer and then a painter, get several bids, you dont have to take the Highest but never take the lowest good luck from Texas

    ...
  •  

    Categories--Copyright/IP Policy--Contact Webmaster