| Do It Yourself (DIY) |
| What do you call those decorative bases for hanging lights? |
sconces are wall lights.
I have seen them advertised as Bezels or Trim Rings, or Medallions.
www dot mariericci dot com/chandelierlarge dot asp ... |
| How do you install a gas furnace? |
I don't know where you live but where I live you absolutely CAN NOT hook up your own gas furnace.
If you ever had a house fire for any reason and the insurance company found out that the furn... |
| Best way to clean and paint a LOT of floor in a Rented Apartment? |
To start with, I try not to answer questions I don't think I have a chance of getting best answer on, but from the question and the answers I'll get out on a limb here.
You said you r... |
| How long do you drain a radiator for? |
The top of the radiator, at one side, the other or the back, will have a little screw in it with a square head, you need a radiator vent key to open it, only turn it anti clockwise for 1 turn, when... |
| What type of house project should I do for my family? |
How about building a couple of really nice birdhouses and putting them on 4 x 4 posts with a climbing plant at the base. This would look really neat and wouldn't cost too much. Plus you coul... |
| How do you fix scratches on a glass stove top? |
Bar Keepers Friend does work very well. This is the procedure that I use with it.... Sprinkle it on liberally, take a wet paper towel and scrub. If you can't feel the scrubbing action, it f... |
| How can I wire a VAC fan from my computer's power supply to plug into a wall outlet? |
Computer fans ARE NOT 120 volts A.C.
Most are 12 volts D.C. ... |
| How do I make a hole in a brick wall to run a new dryer vent? |
Exactly follow as Jedi answered, If you create drill holes as per the shape of the vent your require it will be easier & accurate to break only that part of the brick wall. Otherwise the cracks... |
| What is the best way to remove superglue? |
acetone/fingernail polish remover will dissolve super glue. ... |
| How do you refinish an original hardwood floor? |
In a nutshell, yes. However, it is much harder than it sounds. Check out the link for a step by step process. ... |
| How do I uninstall a water softener? |
Normally all you have to do close the shut off valves that lead in and out of it, cut both the copper piping which leads into the softener and the one which leads out and cap the cut pipes off. The... |
| How do I hang a bike on a brick wall in my apartment? |
The most difficult part is going to be drilling into the masonery. A hammer drill is usually needed but you can get away with a regular drill for something this small. Buy the 1/4" masonery b... |
| How can I pull the nails out of a pallet without ruining the wood? |
I have done this a lot and you have to have a good crowbar. The nails will sometimes break and you will have to dig them out. The first thing is to set your mind to doing it because discouragement ... |
| Does anybody have detailed instructions on how to build a gas powered bicycle? |
any gas engine with the shaft coming out the side will work. Remove the rear fender mount the engine over the rear tire.Use a piece of 2 by 10 to mount the engin to. Flatten the ends of some thre... |
| How to I ungel a can of Nitromors paint and varnish stripper? |
You might try warming it (stand in a basin of hot water) - otherwise it has probably had it and you'll need to get some more. ... |
| How do you build a house from scratch? |
You never want to use old scrap material for lots of reasons, the big reason is that it will more than likely be very crooked.
Crooked wood = crooked walls = easily cracking drywall = bad looking ... |
| How do i fix my washing machine when it comes off-balanced? |
Level the front as a previous person mentioned, and then the back. A quick solution if that doesn't work, though, is to put a piece of rubber matting under the legs of the dryer. It is most ef... |
| Need to find a way to keep bees off hummingbird feeder, but how? |
You may have to change feeders to one with more elaborate bee guards and less dripage. If you can move the feeder to the shades so the sun doesn't heat the air and water inside forcing out th... |
| How old do you have to be to buy a pipe? |
You will have to get your parents to buy a tobacco pipe for you. You have to be 18 to buy a pipe. ... |
| Is there any simple way to increase water pressure in my shower, besides new pipes? |
Try taking the shower head off and soaking it overnight in vinegar. The acetic acid will eat out any scale that may be plugging the holes. OR try replacing it with a cheap hi-flow head, the previ... |
| What is the best material to use to patch a large ceiling hole? |
Find out if it's 5/8" drywall or 1/2", get a piece a little larger than the hole. Ace sells smaller pieces, and sometimes HDepot also. (It should be 5/8" thick.) Then do like... |
| How many hours should I wait to plug my fridge back in after laying it on its side? |
To my knowledge, 24 hours is the suggested wait time. The reason is that the refrigeration fluid runs out of the compressor when you lay it on its side, and you need to let it run back down by sta... |
| How do I add GFCI receptacles in a metal shed w/a 30 amp circuit panel fed from my house panel? |
the easiest and least expensive way would be to make the first receptacle in the circuit a gfci. any other receptacle or fixture down from it is also protected. ... |
| How do you dissolve old glue on a porcelain figure? |
I would try soaking it in clean, warm water to see if it's a water-based glue. Failing that try some solvents. If it's epoxy, you'll have a tough time and expert help may be needed. ... |
| Can I remove the cold water tank from my system and have the hot water cylinder fed direct from the mains? |
The cold tank is actually there for a purpose. It's a settling tank. It prevents excess sediment buildup in the hot cylinder. Removing it is a bad idea however it's location is optional. ... |
| How concerned should I be with sheet rock dust in the a/c-heat return vents? |
You can ask the contractor to do the duct cleaning but if it isn't specifically called out in the contract don't expect him to do it.
You probably be better off just hiring a duct cleani... |
| How do I go about covering a plaster wall with drywall? |
I'd say go with the drywall, except that if you don't know how to apply the mud to the joints it may end up looking pretty cheesy. Cutting and hanging drywall is the easy part, it's... |
| Can you sharpen blades to a blender? |
Yes, almost anything made of metal can be sharpened. Here is how to do it. Take the blade out and run it along the stone at the same angle that is already there, as if you were trying to slice off ... |
| What is the best way to cut wood lattice without it breaking or popping out the staples? |
Safety first. Remember your eye and ear protection, and ALWAYS make sure the blade depth (the amount of blade that will be exposed once the guard is pulled) is no more than 1/8" deeper than t... |
| How can you take a cutting from an established, producing Lemon tree and grow a new tree? |
It's called AIR GRAFTING. You should be able to find excellent directions on WIKIPEDIA on-line! However, the tree produced from this graft may or may not make good lemons. Most citrus is gra... |
| Page:40 Previous-36-37-38-39-40-41-42-43-44-45-46-47-48-49-50-51-52-53-54-55-56-57-58-59-60--Next |
