| Do It Yourself (DIY) |
| What is needed for putting in a second floor? |
Assuming you will laterally brace this assembly adequately, you can use the following:
Posts: 4 columns(3-1/2" sch 40 steel, or an equivalent in a wood product) spaced evenly across each s... |
| After you clean and scuff sand a surface is there a good way to put polyurethane over furniture lacquer? |
Thank you for suggesting some new technologies. It's been awhile since I've worked with furniture, but when using Poly, I've always had to strip off the Lacquers, or varnishes.
... |
| I want to build some wall mounted bookshelves. What is the standard spacings between the shelves? |
"Standard" shelf spacing is about 12", which would accommodate most reference books (at 11"-11.5"). But you need to remember that not ALL reference books are going to be u... |
| How can I drill a hole in a ceramic tile? |
Hey,If you are drilling into softer tile, a regular carbide bit works fine. Do not use a hammer drill as the rapid vibrations can crack the tile. The trick is to use a slow drilling speed and caref... |
| How can I straighten the metal from an aluminum can? |
heat it with something like a plumbing torch, but just heat it enough to bend and not to melt. ... |
| How long does it take putty to dry? |
One of the reasons putty has been used by glaziers for so long is that if painted it never really goes hard and dries out completely.
Putty is used as a sealant more than a fixative, and after i... |
| Should i ventilate the attic when the airconditioner is running to cool of the downstairs? |
you are better off ventilating the attic, not only will it help keep your house cooler, it will also extend the life of your shingles ... |
| Does unfinished furniture still need to be sanded prior to staining if I use a pre-stain wood conditioner? |
Yes.I would sand ...............we used to give any new wood products a water bath with a damp cloth....let it dry and then lightly sand. The water bath causes the grain to raise just a bit and hel... |
| How do I assemble a water dispenser? |
If it is the replaceable clear plastic water bottle, which you get from the water supply place you generally have two types;
1. you pull the whole plastic or rubber cap off the bottle and tip it u... |
| What wires do I need to run a circuit from my subpanel to 2 switches separate switches.? |
That kind of depends on the size of the light bulbs. I will assume they will be 100 watts each. For 12 lights you
will be using 10 amps. You could use a 14-3 cable, but
personally I would use a ... |
| How can i get a white rose to turn blue? |
Put blue food coloring in some water and then put the flowers in the water. It could take a few days for the dye to get all the way finished but it should work. ... |
| How do I run a 100 amp service to an outbuilding from my house? |
thats a tall order.. but.. you would have to install lsomething like two 50 amp breakers fron the MAIN box then run low gage wires to a sub panel box in your out building.... there install anothe... |
| What do I need to do before installing a standby generator in Ontario Canada. Bylaws, permitts? |
You need to first check with the local electrical authority, but generally all you need to have is an automatic transfer switch to make sure that you are disconnected from the grid prior to allowin... |
| Any suggestions on how I can fix a door my self ? |
... |
| How can I get some plans to build a trebuchet? |
The site referenced below has a wide range of plans for trebuchets of all sizes from toy to siege weapon! ... |
| How should I approach cleaning stains from a wood floor? |
I guess laundry detergent might be washed off even if it takes a few goes.
Stains are generally caused by water.
sand back
Wash repetitively with a product called Oxalic acid.
Can be crystals .... |
| Is there any way to clean a silver certificate dollar bill and/or make it look newer/crisp? |
You could probably iron it - but if I were you I wouldn't touch it. Just like with coins, cleaning or trying to improve the appearance of a valuable treasury note or other currency devalues t... |
| Can the bath bombs make bubbles If I put bubble bath in them? |
Grow up! ... |
| How can I measure the angle of my staircase? |
ever heard of trig??? the slope of most stairs is between 31 and 38 degrees. never as steep as 45
and paper cut, 6 in 12 is not 22.5, 5 in 12 is 22.5. ... |
| How do I get rid of the slime or "gunk" that has accumulated along the side of my toilet bowel tank? |
bleach and water combo...
check to make sure the tank is attached tightly to the bowl ... |
| How does the AC come in to my home breaker box & distributed? |
What country are you in? ssup's answer is for UK or other place, and does NOT apply to the US. (The loop method would be against the national electrical code in the US, and not everything has... |
| What is the best way to install ceramic tile? |
The best way is to remove the baseboard trim and tile under it leaving a 1/4" to 3/8" gap to the wall. Then cover that with the trim. If you absolutely do not want to remove the trim th... |
| How can you tell if you have metal or wood wall studs? |
I seriously doubt that galvanized steel studs are behind your drywall. I would however want to check to determine if its drywall or plaster.
I'll assume the pot rack will have to hold co... |
| What special tools are needed to to cut a steel patio door? |
A sawzall, or reciprocating saw with a metal cutting blade, or else a 4 1/2" grinder with a metal cutting blade. Mark both sides before cutting. Cut one side at a time, not the whole door at o... |
| What is the right mixture ratio of cement, gravel and sand, and water? |
1 part cement, 2 parts sand and 3 parts gravel. Add water until it is a uniform consistency. The link below will help you out a lot, you should definitely use it! Good luck!!
... |
| What is the best way to adhere fabric onto wood? |
Spray glue works very well, buy the stuff in the black can at Home Depot, think it's called Super 77, the stuff by Elmer's is okay but not as good. Practise a bit before putting it on you... |
| What kind of black paint to use when wanting to paint pine furniture? |
The "Shabby Chic" look you're talking about usually requires coats of different color paints before your final topcoat, of black in this case. That way, when you sand at the edges, ... |
| How do you unclog a apple core stuck in a toilet? |
Auger it with a closet auger ... |
| How do I get rid of static shocks from metal handle bars? |
Ok first off, you're not getting shocked because of any kind of charge on the bar, you are getting shocked because you are getting a charge walking on the carpet and when you touch the rail yo... |
| How do you get sheet-rock primer over-spray out of concrete floors? |
Do you know if it is it oil or latex based primer? If it's oil based try mineral spirits. If it's latex try either Goof Off or Krud Kutter, both work great on latex paint. Apply the prod... |
| Page:34 Previous-30-31-32-33-34-35-36-37-38-39-40-41-42-43-44-45-46-47-48-49-50-51-52-53-54--Next |