![]() |
|
| *Home>>>Do It Yourself (DIY) |
What should i use to fasten these items onto a wall? |
I am doing an art project on my wall. Don't you know by now??? "Mighty Putty does it all!!!!" glue small nails to the fork and push it into place, like a bigger thumb tack. Super Glue would hold the fork. If you ever wanted to take ti off though then you would damage the wall. What is the wall made out of? I would suggest using anchors in the wall and there are several types that have different heads that can hold different objects. If you have the typical wall ( drywall over studs) Find a stud first for extra stability and drill the anchor into that. you can use hooks or just about anything. Go to a hardware store and tell the guys what your wall is and what you want to stick to it and they should be able to help you . you can take the bonding stuff from the 3M hangers that have the little tab that you pull and it comes right off the wall. You can find them at any local shopping store. Velcro or magnets |
| Related information |
... Yes, buy a new one. The chances of getting a good control board that fits are very small. If it isn't under warrantee, then after you repair it, you have an old unit with an expensive new bo... Use a piece of newspaper to make a pattern to cut the tile. If you lay the tile out up against the toilet and try to cut you will make a big mistake , because it never cuts right. ...Hi - Loosen the nuts on the bolts. Knock a chisel/bolster between the top edge of the timberand the wall just enough to create a small gap. You then have two options - 1. Use a big, coarse toot... You need to re-wire the outlet and install a wall mounted switch, so it is "switched". If your not an electrician, best leave this to a qualified person. Outlets typically are always ON,... Number 2 & 3 are correct. What the process does is show you all the programs currently "active" or rather awake. You can click and end each one not being "used" and it may h... Certainly something is wrong and it is either your thermostat not calling for enough heat or your burner. I would pull off the front sheet metal below the door which almost certainly is held on by... that a big frickin hole.you dont need one that big around.id go about 12".i did some and just poured the mix in dry and tamped it real good.let your garden hose trickle water very slowly so th... |
Categories--Copyright/IP Policy--Contact Webmaster |