|
|
| *Home>>>Do It Yourself (DIY) |
What kind of paint should I use to put a logo on a maple snare drum? |
I am building a custom drum set using maple shells and I want to paint a design on the shells. I've been told that I should etch the design with a sharp knife before painting or it'll bleed. I want the shell to have a natural finish with a clear laquer coat. The design will be in black. What is the best paint to use in this situation? acrylic |
| Related information |
Steam is the best way. If the paper is old and does not respond well, get a scoring device. It will puncture small holes in the paper so steam get get under it. Both the scoring device and steam... The sticky side of the tape goes away from the cutting blade. ...we use 240 volt, 3 pin plug. Is that enough info? SCHUMACHERGI got it wrong, I'm in Australia and we use 240 volt, GET IT RIGHT! Looks like a Y shape. ...Suede is not easy to clean and generally speaking should not be wet cleaned as this only draws dirt further in. A suede brush & nubuck cloth would be your best bet. Use the suede brush to l... If a low level cistern this can be removed and also the toilet itself. Make sure water is isolated. Then remove the cistern first and then the toilet. This will leave a whole in the wall for the wa... "Come on all you plumbers" LOL do you think you will find a plumber at midday on a Tuesday? Scrape old sealant with a sharp blade like a Stanley Knife. Then apply silicone with ... Call an electrician ...Measure the size of the current sink and buy one the same size. Turn off the water supply valves under the sink and disconnect the supply tubes. Remove the trap from the drain piping. The old sink ... |
Categories--Copyright/IP Policy--Contact Webmaster |