|
|
| *Home>>>Do It Yourself (DIY) |
How do I repair minor damage to base molding? |
The base molding in my condo has small dings and chips, including at the top where the molding meets the wall. Is there a way to repair these before painting? Caulk it. Use your finger to fill in the crack and smooth it out. Let it dry and paint if needed. use wood filler clean with bleach then repair with crack filler sand down and put some kind of finish on it the important thing is the hookup of the gas pipe,that there are no leaks,also you need an emergency shut off valve for gas. Use caulk aginst the wall and floor, and use painters putty on the chips in the face. Good luck. |
| Related information |
Try a louvered door. No holes, vents or electrical wiring needed. Any home improvement ctr carries them. ...Most people make molds out of latex with a fiberglass mother mold. Basically you use a little rubber for the detail and the basic shape is held in place with fiberglass. If you want to see pictures... Replacement windows generally do not have a nail-fin for installation and are installed with fasteners through the sash. New Construction windows have the nailfin and are usually installed directly... In your area solar makes the most sense, but you could start small and work up. depending if you have any power source at all at this time? Having an alternative energy source usually means you mus... No - but knowing the right name may help you track down the directions - it may be a kinetoscope. I saw one made from a lampshade kind of thing with another cylinder of paper inside - Something wi... Call some contractors and get estimates. If you plan to do it yourself, the basic steps are: Address any water/leakage issues Frame out the walls Install electrical Sheetrock and texture ... I would go with the memory foam so that after you get off the couch it goes back into the original shape. this also provides the greatest comfort while sitting on the couch. ...I always used a reciprocating saw and cut them off I used duct tape to protect the porcelain its tougher. A hacksaw is hard to do it with because you will be cutting on an angle,if you dont have a ... |
Categories--Copyright/IP Policy--Contact Webmaster |