How do I get my manual recliner to an upright position?

I just bought a manual recliner. It has a lever on its side which I lift to release it to a reclining position. To restore it to an upright position however, I have to get off and push it back in with my hands. Is this how its supposed to work or how do I restore it to an upright position using the lever on its side. Thanks.

Just push it the other way! If it doesn't work, then it's broke and you need to take it back where you bought it. Also you need to push down with your feet as you do.

my kids broke mine and i had to fix it myself and now i cant even open it

Tags

　　Cooking & Recipes 　　Beer, Wine & Spirits 　　Other - Home & Garden 　　Maintenance & Repairs 　　Garden & Landscape 　　Do It Yourself (DIY) 　　Decorating & Remodeling 　　Cleaning & Laundry 　　Other - Family & Relationships 　　Weddings 　　Singles & Dating

Related information

There has got to be some way to MAKE a solap panel, right?

Photovoltaic panels use silicon to generate a charge. I have been considering trying to make some myself.

...

How do you make your own luminaria?

Try a craft store for luminaria bags. Also some party supply places might have them, I got some with pretty designs cut out in the front of the bags at a party store here. If there is a paper compa...

What is the best cheap way to soundproof a room?

It takes a lot of time, but cardboard egg cartons work great.

...

How do I determine if my kitchen drain pipe is frozen under the slab or outside to the septic tank.?

Being where you are, a pro will cost you a small fortune to show up. Home remedy. Open the service cap on the outgoing line and insert a snake to measure out how far the problem is. Get yourself a ...

How can I fit a shower and curtain above my bath without having to drill into walls?

U can buy poles from large diy stores that are telescopic(so they adjust for difrent width walls)& they suction to the wall so theres no drilling or fixings.They would only be any good if ur ba...

How should i install a backflow prevention device to my sprinkler system?

It depends on the local code In MD they charge over $500 to install a $30 device My SIL does it. Type of pipe, depends on whats existing

...

How can I get a piece of shower pipe that broke off out of the threaded end of a copper elbow fitting?

There is a tool that is sold in the irrigation pipe department that is used to remove plastic sprinkler pipes that break off. You stick it in the pipe and it digs into the inside and you unscrew it...

Is concrete block a suitable building material for walls of a house?

I think some people are missing the point. The thermal mass works as a heat sink, absorbing heat during the day, releasing it at night. And it works during the summer and winter. So the R-value ...