www.todaysmodernwoman.com
*Home>>>Do It Yourself (DIY)

How should i install a backflow prevention device to my sprinkler system?


In my underground sprinkler system i have the copper pipe coming out of my house. At that point i am wondering if i can use either PVC or copper to install the vacuum pressure breaker for backflow prevention. Is one material better than the other?

It depends on the local code

In MD they charge over $500 to install a $30 device
My SIL does it.


Type of pipe, depends on whats existing

Hey Steve, I'm currently The Youngest Back Flow Certified Person in the entire state of Maryland, at being only 16 years old, so I may be young, but I know a thing or two about Back Flow Devices. I love walking people threw simple plumbing tasks to save them money, but on a job like this, I recommend calling in a master plumber, that not only is certified(ask over the phone) but also advertises that they install/maintaince them, cause chances are, they'll have a larger knowledge base to help you out better. Any other questions, e-mail me!

WHY??? Why would you need backflow prevention in a sprinkler???

Tags
  Cooking & Recipes   Beer, Wine & Spirits   Other - Home & Garden   Maintenance & Repairs   Garden & Landscape   Do It Yourself (DIY)   Decorating & Remodeling   Cleaning & Laundry   Other - Family & Relationships   Weddings   Singles & Dating
Related information
  • How can I get a piece of shower pipe that broke off out of the threaded end of a copper elbow fitting?

    There is a tool that is sold in the irrigation pipe department that is used to remove plastic sprinkler pipes that break off. You stick it in the pipe and it digs into the inside and you unscrew it...

  • Is concrete block a suitable building material for walls of a house?

    I think some people are missing the point. The thermal mass works as a heat sink, absorbing heat during the day, releasing it at night. And it works during the summer and winter. So the R-value ...

  • How to loosen a stripped and rele tight screw from a paintball gun.?

    Drill off the head of the screw with a drill bit of the same size....once the screw head is off, you can remove the trigger and hopefully have enough screw shank left to remove with a visegrips or ...

  • What would i have to do to install shower heads on both sides of a tub/shower combo?

    Since converting the tub to a shower would mean the wall would be down to the studs, it would be a simple procedure for a plumber to run new piping for another shower head. However the available w...

  • How does a toilet flapper work?

    Under normal circumstances the modern toilet only uses about 1 1/2 gallons of water to flush. That's actually all that's needed for it just being peed in. For the "other" you n...

  • What is the cheapest hardwood to use for kitchen cabinet face frames?

    The two least expensive hardwoods are oak and maple. Oak is less money and fairly to work with as hardwoods go.

    ...
  • I accidently dropped a thin plastic cannister in my toilet as it was flushing. How can I get it out?

    A snake would only push it further down. Your best bet is to unbolt the toilet from the floor and remove it so you can get something to get ahold of it and remove it. You may even have to drill a h...

  • What is the easiest way to build a chicken coop?

    Chicken wire and posts. Post out the area, then attached the chicken wire....the posts have hooks. You will also need a place for the chickens to roost or lay eggs. Here's a site to give yo...

  •  

    Categories--Copyright/IP Policy--Contact Webmaster