|
|
| *Home>>>Do It Yourself (DIY) |
How do you get rid of sticky stuff from an ethernet cable? |
We taped our ethernet cable down to the carpet with masking tape for a year, and now need to clean it off; however, there's sticky residue left on the ethernet cable after we peeled off the masking tape. We've tried Purell, nail polish remover, and I've heard of using rubbing alchohol, but would anything else work? Alcohol or nail polish cleaner do not dissolve the glue, that's why that does not work. Apparently either mayonnaise or peanut butter on a piece of cloth will remove it. WD40 or GOO GONE either will work well Use a commercially available product called "Goo Off" Available in any good department or hardware store A good cleaner like 409 should do it. Just saturate your cleaning cloth and wipe away the glue residue. A small piece of cloth or a used fabric softner sheet that you get out of the dryer dabbed in Pine Sol that you may have in your kitchen cleaning supplies would clean it. |
| Related information |
about 3/16ths of an inch or so ...first of all find a solar panel that will put out 250 watts, by the way you did not state what the voltage is on the light, if its 220v goodluck, there's a smaller complete solar unit for ga... It shouldn't be flammable at all. Spray some on a fireproof surface like a cook top and put a match to it. If it was the propellant used in some which contains some propane, it should long ... Try laying out the curve on the ground ahead of time,use some spray paint to make your curve. To make it a little easier make your lower support posts line up with upper rail posts. As far as plac... You could bug bomb it. It's a can of aerosol spray you find at Home Depot or Lowes in the bug section and you put it in the middle of the bathroom, press the button, then get out of the bathro... Practice makes purfict, just do it read the instructions,Keep other pepole away while in use , It won,nt take long and you will be a pro, I.ll never forget my first time on a power saw. ...This is one of those things that if you have to ask you probably shouldn't attempt it. There are several safety items like venting sizeing , length, and number of turns. each would affect t... This may not be the best, but it works the best for me. I take them down, stand them up (spread out) in the shower, spray them with Fantastic, or 409, or you can use equivalent, and then run scald... |
Categories--Copyright/IP Policy--Contact Webmaster |