|
|
| *Home>>>Do It Yourself (DIY) |
I want to use a 250 watt hid light in my out building powered solely by solar panels where would I start? |
250 watt hps HiD light , solely on solar panels , inside my out building running from 3 - 18 hours per day. first of all find a solar panel that will put out 250 watts, by the way you did not state what the voltage is on the light, if its 220v goodluck, there's a smaller complete solar unit for garages , but you might have to put in more to get the light you want, the solar panel to run and keep a 250 watt hid light fixture lit would be bigger than the outbuilding depending on where you live, home depot will have solar kits. or there is susually a local contractor who deals in solar. try to find them online. also, several places in the hudson valley in NY make and ship them. also, c.crane or ramsey is stocking solar panels too. You're going to need a LOT of solar panels to run that. Assuming you want to run it 12 hours a day, and live in an area that has 5 hours of sun bright enough to generate power through a solar cell, and you assume the efficiency of storing the power in a battery, then converting it to AC for the HID is at 75%, you're going to need roughly 800 watts of panels. At roughly $8/watt for panel + inverter + batteries... you're talking roughly $6400... |
| Related information |
It shouldn't be flammable at all. Spray some on a fireproof surface like a cook top and put a match to it. If it was the propellant used in some which contains some propane, it should long ... Try laying out the curve on the ground ahead of time,use some spray paint to make your curve. To make it a little easier make your lower support posts line up with upper rail posts. As far as plac... You could bug bomb it. It's a can of aerosol spray you find at Home Depot or Lowes in the bug section and you put it in the middle of the bathroom, press the button, then get out of the bathro... Practice makes purfict, just do it read the instructions,Keep other pepole away while in use , It won,nt take long and you will be a pro, I.ll never forget my first time on a power saw. ...This is one of those things that if you have to ask you probably shouldn't attempt it. There are several safety items like venting sizeing , length, and number of turns. each would affect t... This may not be the best, but it works the best for me. I take them down, stand them up (spread out) in the shower, spray them with Fantastic, or 409, or you can use equivalent, and then run scald... If it doesn't have a primer, use starting fluid. If it has a primer, usually its called for only 3 times... replace the airfilter, make sure the oils fresh and up to the full mark on the dipst... Remaining glue will not come off by soaking in water. It can be removed with all the oil based solvents mentioned, like cigarette lighter fluid (works great) WD-40, and Goo-Gone, which all work ... |
Categories--Copyright/IP Policy--Contact Webmaster |