How do I figure out the placement of post for a curved deck?

This deck is straight for the most part except for one corner which will have steps to the yard. The steps will be on the corner that i want to curve, it will be gradual.

Try laying out the curve on the ground ahead of time,use some spray paint to make your curve. To make it a little easier make your lower support posts line up with upper rail posts.
As far as placement that really depends on the radius of your curve,but once you figure your curve you will have a much better idea of where to put your posts
Good luck on your deck.
Have A Great day!

you need to be more specific w/your question. when you say post I'm assuming your talking about a post for support, correct? what i need to accurately answer your question are as follows; height, length & width. what it will be attached to, a rough schematic (drawing) would be wonderful.

i would put the post every 4 foot apart, that would give you support, & that is very important on a deck

Tags

　　Cooking & Recipes 　　Beer, Wine & Spirits 　　Other - Home & Garden 　　Maintenance & Repairs 　　Garden & Landscape 　　Do It Yourself (DIY) 　　Decorating & Remodeling 　　Cleaning & Laundry 　　Other - Family & Relationships 　　Weddings 　　Singles & Dating

Related information

How do I clear my bathroom of spiders?

You could bug bomb it. It's a can of aerosol spray you find at Home Depot or Lowes in the bug section and you put it in the middle of the bathroom, press the button, then get out of the bathro...

How do I get over my FEAR of chop skill saws?

Practice makes purfict, just do it read the instructions,Keep other pepole away while in use , It won,nt take long and you will be a pro, I.ll never forget my first time on a power saw.

...

How do I vent a gas hot water heater?

This is one of those things that if you have to ask you probably shouldn't attempt it. There are several safety items like venting sizeing , length, and number of turns. each would affect t...

What is the best way to clean vinyl blinds?

This may not be the best, but it works the best for me. I take them down, stand them up (spread out) in the shower, spray them with Fantastic, or 409, or you can use equivalent, and then run scald...

What am i to do if i cant get a lawnmower to start? Any suggestions, anyone?

If it doesn't have a primer, use starting fluid. If it has a primer, usually its called for only 3 times... replace the airfilter, make sure the oils fresh and up to the full mark on the dipst...

What do you use to get the remaining adhesive from a sticker off of a glass container?

Remaining glue will not come off by soaking in water. It can be removed with all the oil based solvents mentioned, like cigarette lighter fluid (works great) WD-40, and Goo-Gone, which all work ...

How to build a wooden picket fence?

Check the contour of the land ensure that the area that the fence is straight and check if there is an incline (like hill side) build the fence in managable sections.Plant your two extream post, r...

What type of wood and material should I use for a polyurethane mold?

Here's what you do: Use a flat piece of pine or birch 3/4" to 1" thick. Draw out the shape of the curved face or streetside of piece. Then glue a big square chunk carvable styrofoam ...