|
|
| *Home>>>Do It Yourself (DIY) |
How do you open a front loading dryer to change the belt? |
I need help right away. The maytag people will not give out this info, they want you to pay for their services! Disconnect the power. then look at this link for more info. Pull it away from the wall and take the back off. You will have to disconnect the gas line, but it is a relatively easy job to replace that belt. It surrounds the drum. Depends on the model.If there's a seem along the top it will pop off if you pry it up.Some can be accessed from the under side.Just tip it over on it's front or side. take the cover off. look in the manual for screw locations. every dryer is different, but there is probably a few screws that keep the cover on. as soon as you take this off, you will see the belts. the top will lift up. Then remove about 6 screws on the inside front and lift up the drum. |
| Related information |
Well, you could buy the little storage units like they sell at any home improvement store. They should be going on sale right about now. ...you might have to move some cabinets, just make the available opening 24 inches, plus one inch so you have room to maneuver it into place ...If the drain is PVC, you just cut the flange off and glue one on with PVC pipe glue. The problem you may run into is once cut the pipe may not be long enough. If that is the case, you will have to ... yes it is okay. but only mix water based together or oil based together. Just read the clean up instructions on the cans. if it says that you can clean up with soap and water it is water based.... Topcoats : --------------- HSLD 5000 Resin / Catalyst Porcelain Enamel 1000 Resin / Catalyst Protecthane Iso-Free Resin / Catalyst Primers ----------- XL Aerospace Resin / Catalyst ... Try putting rubber padding between the gate and where it bangs. ...Put a small cage around it to prevent them throwing objects at it. ...Is the float arm (ball valve) falling when the toilet is flushed? if it is, is it going all the way down or is the valve sticking closed? If neither of these is the problem, and from your descri... |
Categories--Copyright/IP Policy--Contact Webmaster |