|
|
| *Home>>>Do It Yourself (DIY) |
What paint do I use to paint the front of the dishwasher and the oven hood? |
We just bought new appliances, fridge and oven, but the dishwasher and oven hood work fine, so we kept them. The new appliances are black, the older things are almond. What paint do I use to paint them? Is there paint that can be applied with a brush available since spray can spatter is a mess. you dont want to paint these items with a brush... i dont care how straight and steady your hand is... you will see brush marks... it will not be pretty... a roller on these products will leave pitting... the best thing to do is to get a sprayable paint.... meant for resisting higher temps... use plastic sheathing and tape... cover all the items in the area or take it out side and spray it... if you want it to look nice for a cheaper penny... its not gonna be as easy as slapping paint on it with a brush or roller... if you do it wrong you might end up having to get new appliences... call the manufaturer and find out the actual finish on the appliences that you had purchased and purchase it from them or any retailer that carries that line of paints... good luck! Take your panel off your dishwasher, and it my have a black panel on the other side. a lot dishwashers come with two panels or a different color on the other side. I believe they sell a metal paint specifically for appliances as such but it usualy comes as a spray can enamal. Oh Yes, Home Depot,Walmart has a paint/spray paint for fridge, oven and it works great. Just surf the store and make sure the bottle says for Stove tops/Ovens. Good Luck! Home Depot or Lowe's has this "stainless steel-like" thing that you can peel off and cover appliances with. I painted my white range hood black using oil based paint & a foam brush. It doesn't show brush marks because the hood is textured. It looks good & is very scrubbable. I haven't gotten up the nerve to try it on my other appliances though. most dishwashers allow you to change the color. Just remove the almond colored panel from the frame and there should be a black one behind it. refer to your owner's manual. Krylon Appliance Epoxy Spray Paint - Cans |
| Related information |
If they really are in "series" as you say, if you unscrew the bulb in one, the other one will go out. I think you mean they are on the same circuit (but in parallel). Next, how is the tw... HAND quilting thread is always 100% cotton, usually mercerized (treated with caustic alkali under tension to increase strength, luster, and affinity for dye), and is often coated to avoid tangling.... A brick is the same size as the block 7-5/8 if you lay the brick as a sailer (on edge to hide holes) so it should line up perfectly ...Its OK to skim coat or texture over a painted wall, and yes prep work is everything for how well the job will look and how well it will last. SO do not skimp on the prep. Watch out for wall paper... I like the idea of motion sensors connected to flood lights. They're relatively inexpensive. If it happens at night, it should be easy enough to scare them off or catch them. They may even ... using a 1" conduit pipe drill holes in end affix a screw eye system to it hang from ceiling with say a 1 1/2 inch screw then hang curtain like a shower curtain? IDEA/ ...I have a Stratocaster and all u have to do is unscrew everything an remember how to put it back. I suggest not loosing the screws. Put them in a bag or something. ...your talking about building the most expensive parts of a home (kitchen and bath) so its not going to be cheep and depends on the size of room....do much of the work yourself to save money...pick u... |
Categories--Copyright/IP Policy--Contact Webmaster |