|
|
| *Home>>>Do It Yourself (DIY) |
How does a person find a local market for unfinished clay products and a kiln, probably last used in the 50s? |
The areas of Cleveland & Toldeo, OH, Detroit, MI and anything in between would be preferred. If I understand your question correctly, you are looking to sell a used kiln and greenware/bisqueware? List them on your local craigslist under the arts and craft category. I got my potter's wheel from a seller on craigslist, he had an old kiln too but it was in bad condition so i passed on it and only bought the wheel. List the condition of the kiln correctly, like what model it is, interior chamber size, what temp it is rated for, any brick damage, does it have a kilnsetter, does it work etc. Also post a photo of the kiln for best response. There are plenty of clay newbies willing to purchase used equipment but expect a mucher lower price if your kiln doesn't have a kilnsetter or has major brick damage. The link below has a phone # and email link. Maybe call them and see what they can offer. |
| Related information |
Marble rolling pins are AWESOME, and you dont have to put them in the dishwasher, run hot water over it and everything on it rolls right off. HUGE fan of marble ...some tide powder in hot water disolve the powder thuroughly, then add some bleach,,,,,,vaccum really well befor and after cleaning........ ...Go to the Salvation Army website and look for their Donation Value Good. They list the fair market value for all kinds of things - clothing, appliances, books, etc. Also check out the IRS site for ... Your flapper valve is leaking. That is the rubber flap at the bottom of the tank that lifts when the handle is depressed. ...Measure the existing ones. You will find that there is a long and a short spindle for each tread. The spindle bottom section can be trimmed , but,most turned spindles are set so that the bases a... Since you know the wall is not going up or down, all the anchor needs to do is keep the bottom plate from moving in and out. Almost any of the options mentioned will accomplish this. Drilling and i... The seat cushions on mine have ties. If yours don't have any then you can get some bias binding from the notions dept at someplace like Walmart or at a fabric shop and sew them onto the cushio... As a couple of others have stated, the most common cause of a pilot light going out, is the thermocouple. Its a relatively inexpensive part, and not too hard to change out. You mention this was... |
Categories--Copyright/IP Policy--Contact Webmaster |