|
|
| *Home>>>Do It Yourself (DIY) |
How do I give a square nightstand a round top ? |
I have a small nightstand and I want to add a round top to. I would like it to be about 18 inches in diameter but I don't know where to get a round piece to attache to the top. Precut circular wood tops are available that you could finish and attach. Try Lowes or Home Depot for that. A glass one might be interesting. You can buy round precut glass tops at Target that are inexpensive. They are a about two feet across. They make glass round tops about that size that they sell for those 3 legged tables with round tops that you cover with material. You can buy the round piece at K-mart or Wal-Mart. Like I said it is glass but you could get one of those covers or not cover it and put pictures under the glass? Micheals, Home Depot, World Bazaar, Pier One, these places sell round glass ops in many sizes all pre cut Don't even think about adding a new wooden top. It will not look good, and will never match the base. I would even question the value of trying to get a new glass top. If you really can't find any pre-cut table tops to your specifications, you could go to your local carpentry store and purchase plywood. You can have them cut it to your desired shape and diameter. Then you could nail it to the existing nightstand. You could then stain/paint the nightstand and the table top in the same color so that it looks more unified. Good luck! Home Depot |
| Related information |
Use stick and peel glue available at Pearls Store or your nearest Stationary store.Is there any painted back ground on your canvass sheet?you can use a push pin to hang up your picture on a canvas... These might help ... I don't know much about hay, except to make it while the sun shines, but I know a little something about building. Use caution when cutting through the floor. Those joists double as collar ... Certainly these products are suitable for a second floor, but make sure your kitchen floor is properly supported. I suggest you first determine why it sags in the middle. It could be that you hav... After growing up on a Chicken farm this is an easy task, relatively speaking. Certainly you should add posts. Yes you should anchor the fencing by some method, to the ground. (Chickens do dig; and ... when cutting Formica always cut from the back side. use masking tape on front side in the center of scribed lines. cut Formica with a fine tooth finish blade on your skill saw , always cut slightly... If you're writing a story, you want to make it believable. Do NOT have the person use an axe. That is WAY too much work, and far too time-consuming. Let them use a chain saw to fell the tre... A circular saw is the best but since it is chipping your piece turn the plank over and run the saw cutting the bottom or use tape and then run the saw. Should work well. My husband did not have any... |
Categories--Copyright/IP Policy--Contact Webmaster |