www.todaysmodernwoman.com
*Home>>>Do It Yourself (DIY)

How to install chicken wire for chickens?


I am putting up a chicken run for my chickens, 5x5 feet. I have metal T-posts at each of the corners. Is that good enough or do I need more posts in between, such as those used for electric fencing?

How do you stretch the wire so that it is taut? Thank you!

After growing up on a Chicken farm this is an easy task, relatively speaking. Certainly you should add posts. Yes you should anchor the fencing by some method, to the ground. (Chickens do dig; and can find there way OUT)

Someone to help would help also, in that one stretches (by hand is fine; While the other hooks the fencing to the hooks on the posts. Chicken wire is NOT at all difficult to stretch and it need not be as tight as chain link. Besides a 5 x 5 is tiny.

Forget middle posts; just anchor the wire between any post of area the ends are secured to.

Steven Wolf

make sure the wire at the bottom is small so raccoons cannot reach in and grab your chickens i lost 8 chickens because my wire was to big at the bottom :( Report Abuse

Shouldnt a farmgirl know how to put up a TINY chicken pen? You should have learned that by the time you were 7 or 8.

Just kidding, you should be just fine as long as you have sturdy corner posts and they are set in the ground far enough to keep them from bending when you stretch the wire.

I would put some posts in between the corners.. Wooden stakes would be better that way you can staple the wire to them and keep it taut or just get pieces of copper wire and tie to the posts.. Have someone pull the wire taut as you tie it to the stakes.

Tags
  Cooking & Recipes   Beer, Wine & Spirits   Other - Home & Garden   Maintenance & Repairs   Garden & Landscape   Do It Yourself (DIY)   Decorating & Remodeling   Cleaning & Laundry   Other - Family & Relationships   Weddings   Singles & Dating
Related information
  • What is the best way to cut formica countertop?

    when cutting Formica always cut from the back side. use masking tape on front side in the center of scribed lines. cut Formica with a fine tooth finish blade on your skill saw , always cut slightly...

  • How many trees to a cord of wood?

    If you're writing a story, you want to make it believable. Do NOT have the person use an axe. That is WAY too much work, and far too time-consuming. Let them use a chain saw to fell the tre...

  • What is the best tool/method to use for cutting laminate flooring?

    A circular saw is the best but since it is chipping your piece turn the plank over and run the saw cutting the bottom or use tape and then run the saw. Should work well. My husband did not have any...

  • What is the best way to split wood without a wood splitter?

    a Maul and a wedge, use a wedge called a "Wood Grenade" it is "Round" NOT squar like the other wedges, it requires LESS effort to split the wood, tap it in the log, keep kness c...

  • What is the easiest (and cheapest) way to print onto glass or perspex?

    Vinyl decals.............

    ...
  • Is there an online site that sells non controlled chemicals to individuals?

    You can try ebay one seller link below. Most other places you would need a business and a tax number to buy from. Good luck

    ...
  • My daughter has dozens of headband and no way to store them. Any ideas ?

    I put mine in a wicker basket on top of my dresser.

    ...
  • How can I learn how to polish different kinds of metals like stainless steel and aluminum?

    I have no true memory of the substance but used to work for Lockheed Martin as a model maker. I used a lathe with a soft, multi layered buffer and a rouge block that was essentially like a hardened...

  •  

    Categories--Copyright/IP Policy--Contact Webmaster