|
|
| *Home>>>Do It Yourself (DIY) |
How do i reconnect volage wires to turn on my fire place? |
My fire place switch does not work. There are 2 wires inside a box 1 white 1 black how do i reconnect them? They are low voltage. Um, how do you know they are low voltage? No offense, but you sound like you don't know much about electricity. You might be better off getting a pro to look at that. They were likely disconnected for a reason. Fireplace control systems can vary widely in their operation. u have a switch with two lugs? it doesn't matter which one goes to which. |
| Related information |
Yes a mirror on the opposite side of your room, or an the wall perpendicular to the window so you can kind of beam the light all over your room. I would also say to keep your curtain or window trea... The standard cabinets that come from Home Depot, etc., have holes for two ovens and extra wood below a top doored cabinet and extra wood above a bottom shallow drawer. The size of the the cutout f... I found a web site that describes how to do just that. Check it out. ... Well sure you can. If your house is frame construction, it's not built with pressure treated studs. If your shed is going to sit directly on the ground, you might want to have the bottom pla... Defacement of Currency Defacement of currency is a violation of Title 18, Section 333 of the United States Code. Under this provision, currency defacement is generally defined as follows: Whoeve... You have to find a piece of drywall to fit into it. Get a drywall saw and cut away the ragged parts of the hole (or use a steak knife) - shape it into a nice square or rectangle. You'll want... hand power is ok, or remove the skirting to get the big machine closer. ...I think Ellie must have misunderstood your question. ;-) What you can do is take a piece of wood and cut to the required length. you will need to attatch a chain to both ends or you could use so... |
Categories--Copyright/IP Policy--Contact Webmaster |