Where can I find plans to build a double oven enclosure?

I am remodeling the kitchen and have bought a double oven, now I need to build the enclosure from scratch but I can't find any specs. Does any one know where I can look for some plans or saftey specs?

The standard cabinets that come from Home Depot, etc., have holes for two ovens and extra wood below a top doored cabinet and extra wood above a bottom shallow drawer. The size of the the cutout for the oven is given in the installation directions along with the locations of the gas and electricity (even with gas, the timer, etc., needs 120). We cut the opening low so that my short wife would have good access.
The cabinet is built like any cabinet. I have some woodworking skill but never thought of building ours (I installed them) since I wanted them to match, get done quickly and be a saleable addition to the house.
If there is one thing I would add, it would be a vent to outdoors that was heat controlled so that oven heat went out instead of into the house.

Go to a place that sells kitchen cabinets and look at the their double oven cabinets. That will give you an idea of how it needs to be built to accommodate yours.

Look at the installation instructions that come with the oven. If you didn't get one, contact the manufacturer and ask them to send you one. Once you know what you need to install the oven, you'll know how big the cabinet has to be to accommodate it.

Good Luck!!

Tags

　　Cooking & Recipes 　　Beer, Wine & Spirits 　　Other - Home & Garden 　　Maintenance & Repairs 　　Garden & Landscape 　　Do It Yourself (DIY) 　　Decorating & Remodeling 　　Cleaning & Laundry 　　Other - Family & Relationships 　　Weddings 　　Singles & Dating

Related information

How do I build a ceramic kiln?

I found a web site that describes how to do just that. Check it out. ...

Can I use regular studs instead of pressure treated studs if I want to build a tool shed?

Well sure you can. If your house is frame construction, it's not built with pressure treated studs. If your shed is going to sit directly on the ground, you might want to have the bottom pla...

Is it illegal to drill a hole through a quarter?

Defacement of Currency Defacement of currency is a violation of Title 18, Section 333 of the United States Code. Under this provision, currency defacement is generally defined as follows: Whoeve...

How do I fill a hole in the wall, that is the size of a closed fist?

You have to find a piece of drywall to fit into it. Get a drywall saw and cut away the ragged parts of the hole (or use a steak knife) - shape it into a nice square or rectangle. You'll want...

What is the best way to sand the edge of the wooden floors?

hand power is ok, or remove the skirting to get the big machine closer.

...

Does anyone have any ideas on making my own pool table light out of plastic and wood?

I think Ellie must have misunderstood your question. ;-) What you can do is take a piece of wood and cut to the required length. you will need to attatch a chain to both ends or you could use so...

What to do with water heater and water softner when draining water from plumbing?

turn off the heater. shut the valve to prevent siphoning. by-pass the softener. install water hammer devices sold at your hardware store. you may need a few if four house is big. if you need to you...

How can I turn a twin bed temporarily into a chaise?

You also can purchase pillow roll blanks at the fabric stores in a variety of sizes to use as back cushions. Two of the round long one work on the back of a twin to turn it into a couch. No sewin...